Innovative Technology of America ITATRAN 用户手册

Drill Template 
8-32 Button heads screws 
Interconnect (power) cable  

 

 

 

 

 
2.  Tools required 
 
 

Wire stripper 
Screwdriver with “Allen Wrench” head 

 

Drill and #18 bit (8-32 screws) plus 1.2” bit (antenna aperture) 

 

Tube of clear silicon gasket seal 

 
3.  Mounting the transmitters  
 

3a. 

Place the drill template at the desired location.  Drill the four holes with  

 

the #18 bit.  Repeat this procedure at the other end of the vehicle.  Drill  

 

out the center hole with the 1.2-inch bit. 

 
 

3b. 

Coat the front metal surface only with clear silicon gasket seal. 

 
 

3c. 

With one person inside with the transmitter and one outside align the  

 

transmitter and mount with the 8-32 screws.  Wipe off any sealant the may  

 

 

be on the clear lens of the antenna. 

4.  Wiring  
 
 

4a. 

Power Connectors.   

 

 

Connect the black wire to chassis ground. 

 

 

Connect the red wire to one of the red wires from switch box if manual  

 

 

turn-on/off of the transmitters is desired.   

 

 

Otherwise connect red wire to the desired 12-volt power source in the  

 

 

vehicle. 

 

 

Connect the green wire to one of the green wires from the switch box. 

 
 

4b. 

Switch box.   

 

 

Green wires connected per above. 

 

 

Black wire to chassis ground. 

 

 

Red wire labeled “power” to 12-volt power in vehicle (manual turn-on/off) 

 

 

Two red wires (unmarked) per above for manual turn-on/off 

 

 

NOTE-Red wires are not connected if manual on/off is not desired. 

  

January 1,  2001