Справочник Пользователя для Wilson Electronics LLC 2B1225

Wilson Electronics signal boosters are bi-directional devices that deliver service levels 

consistent with what would be expected in areas of high cell network coverage .  They 

amplify a weak or shadowed signal in mobile, marine and in-building applications .

When using a Wilson Electronics signal booster in conjunction with Wilson Electronics 

antennas, the outside antenna will collect the cell tower signal and send it through the 

cable to the signal booster .  Cell phones and cellular data cards then communicate with the 

improved signal .  When a cell phone or cellular data card transmits, the signal is amplified 

by the signal booster and broadcast back to the cell tower through the outside antenna .

An external adapter is required to connect the cell phone or cellular data card to the signal 

booster.  The external adapter is cell phone/data card-specific and may be purchased 

through a local retailer . Refer to Wilson Electronics Adapter Guide to identify the correct 

adapter for your cell phone or cellular data card . The adapter guide is available through a 

local retailer or at www.WilsonElectronics.com . The external adapter plugs into the antenna 

extension cable (included) and directly into a socket on the cell phone or cellular data card .

The external adapter and the extension cable are long enough to reach the signal booster 

location .  This allows for ease and convenience of use . Run the extension cable from the 

external adapter and attach it to the connector labeled “cellular phone or data card” on the 

signal booster .

Select a location on the top of the structure to install the outside antenna that has the most 

unobstructed line of sight to the cell tower . To obtain maximum performance, the antenna 

should point toward the cell tower .  Follow the instructions included with the outside 

antenna and the RF Safety Warning (page 5) .
Lightning protection is recommended for all stationary installations .  
Take extreme care to ensure neither you nor the antenna come in contact with any electrical 

power lines . 
Ensure there are at least three feet of clearance in all directions surrounding the antenna .

Select a location to install the signal booster that is away from excessive heat, direct 

1 . 

sunlight, moisture and that has proper ventilation .  Ensure the signal booster is 

installed within six feet of where the cell phone or cellular data card will be used (to 

accommodate the six-foot adapter extension cable) .  
Run the cable from the outside antenna and attach it to the connector labeled “outside 

2 . 

antenna” on the signal booster .