Справочник Пользователя для Spectralink Corporation WRFP4-2G4
You can use instructions in point B for alternati-
vely configuration method (if you do not have
access to the tool and a PC)
vely configuration method (if you do not have
access to the tool and a PC)
B.
1
1
Turn on the base station and a subscribed
handset.
handset.
2
Turn on the Repeater (WRFP) for more than 1
second and less than 5 seconds (note 1). Turn
off the WRFP and turn it on again. The WRFP is
now in subscription mode. This is indicated by a
flashing LED immediately after power is switched
on. In this mode the WRFP is searching for a
Fixed Part in subscription mode. This mode is
active for maximum 5 minutes. If the subscrip-
tion procedure is not completed within this time,
the WRFP restarts in normal mode with previous
subscription data.
second and less than 5 seconds (note 1). Turn
off the WRFP and turn it on again. The WRFP is
now in subscription mode. This is indicated by a
flashing LED immediately after power is switched
on. In this mode the WRFP is searching for a
Fixed Part in subscription mode. This mode is
active for maximum 5 minutes. If the subscrip-
tion procedure is not completed within this time,
the WRFP restarts in normal mode with previous
subscription data.
3
Start subscription mode in the base station.
The usual procedure is pressing the button on
the base station for some seconds. This is the
mode normally used when subscribing a handset
to the base station (note 2).
The usual procedure is pressing the button on
the base station for some seconds. This is the
mode normally used when subscribing a handset
to the base station (note 2).
4
The WRFP is synchronised with a base station in
subscription mode. This is indicated by a fast
flashing LED.
subscription mode. This is indicated by a fast
flashing LED.
5
Verify that the WRFP is synchronised with the
requested base station. This is done by pressing
the Hook-key or INT-key on the handset. The
LED on the WRFP (visible at the front center of
the WRFP) should light up steadily. If the LED
does not light up after pressing the Hook-key or
INT-key a few times, the WRFP is probably
synchronised with another base station. If this is
the case the subscription procedure has to be
repeated from step 2.
requested base station. This is done by pressing
the Hook-key or INT-key on the handset. The
LED on the WRFP (visible at the front center of
the WRFP) should light up steadily. If the LED
does not light up after pressing the Hook-key or
INT-key a few times, the WRFP is probably
synchronised with another base station. If this is
the case the subscription procedure has to be
repeated from step 2.
Reapeter 1405 7301 ed1 28/09/01 11:41 Page 4