Справочник Пользователя для AeroScout ANT4200
AeroScout EX4200 Ultrasound Exciter
EX4200 Features
8
LED Indications
The front panel of the EX4200 Exciter includes one green LED that blinks when
transmitting.
transmitting.
Connectors Panel
Figure 2 describes the Exciter connector panel (bottom panel).
Figure 2: AeroScout EX4200 Exciter Connectors Panel
1. Ethernet LAN Connection – RJ-45 interface. In a configuration that uses a physical
Ethernet cable connection to the LAN, the network cable is attached here. Permanent
connection to a wired network is not mandatory. However you must have a wired
connection for configuring the Exciter. In addition, some of the monitoring functions
will not be available if the Exciter is not wired. This connection is also used for
Power over Ethernet (PoE, 802.3af).
Ethernet cable connection to the LAN, the network cable is attached here. Permanent
connection to a wired network is not mandatory. However you must have a wired
connection for configuring the Exciter. In addition, some of the monitoring functions
will not be available if the Exciter is not wired. This connection is also used for
Power over Ethernet (PoE, 802.3af).
2. Power jack – Accepts an input voltage of 48V DC. This is a standard 2.5mm jack
connector for direct power supply. Alternatively, you can use the power supply that
is packaged along with the Exciter. When PoE is used, this connection is not used.
connector for direct power supply. Alternatively, you can use the power supply that
is packaged along with the Exciter. When PoE is used, this connection is not used.
3. Chain IN Connector – RJ-45 connector. This connector is used for receiving power
from chained Exciters.
from chained Exciters.
4. Chain OUT and Control Connector – RJ-45 connector. This connector is used for
distributing power to chained Exciters and to connect the External LF Antenna unit.
The output voltage is 12V DC.
distributing power to chained Exciters and to connect the External LF Antenna unit.
The output voltage is 12V DC.
5. Auxiliary connector – Designed for connecting an External Speaker unit.
WARNING: The auxiliary connection is for connecting an External Speaker
unit only. Connecting other devices or a POE connection to the auxiliary
input may harm the Exciter.
unit only. Connecting other devices or a POE connection to the auxiliary
input may harm the Exciter.
1
2
3
4
5
5
5