Справочник Пользователя для CipherLab Co. Ltd. 1664

Enter Setup

1664 Barcode Scanner

User Guide

After establishing a WPAN connection successfully…

1. Once a WPAN connection is established successfully, the scanner will stay active for a specified

period of time (2 minutes by default) for data transmission. Its CPU is running at full speed,

and the LED is flashing blue (On/Off ratio 0.02 s: 3 s).

2. If it is idle within 2 minutes, the scanner will become inactive to save power for the remaining

period of time (the specified value minus 2 minutes). Its CPU is running at low speed, and the

LED is flashing red (On/Off ratio 0.3 s: 2.5 s).

Press the [Trigger] key to wake up the scanner when it becomes inactive, and the scanner will

stay active again.

3. If it is idle and finally stays inactive until the specified time interval for Auto Power Off has

elapsed, the scanner will automatically turn off in order to conserve battery power. The three

short beeps will ring out, tone descending from high to low.

Hold down the [Power/Delete] key for about 2 seconds to turn it on.

For Bluetooth

HID, the scanner will resume connection with the host upon powering on

again, as long as the host application is running. The three short beeps will ring out, tone
ascending from low to high. If the scanner fails to resume connection, it will try every 5

seconds to re-connect to the host unless the scanner read the “Reset Connection”

barcode.

For Bluetooth

SPP Slave Mode, the scanner must wait for the host to re-connect.

For Bluetooth

SPP Master Mode, the scanner will resume connection with the host upon

powering on again, as long as the host application is running. The three short beeps will

ring out, tone ascending from low to high. If the scanner fails to resume connection, it will

try every 5 seconds to re-connect to the host unless the scanner read the “Reset
Connection” or “Restore System Defaults” barcode.

With the use of 3610, the scanner will try re-connecting to 3610 unless to turn off the
scanner.