Справочник Пользователя для VDA MULTIMEDIA SPA 65000W0
Step 3 : Preparation
Preparing the television
The OnAir SBB works best when it can control the television using HDMI CEC protocol, CEC
protocol is implemented in most in modern televisions.
Enter the televisions configuration menu using the televisions original remote control unit and
confirm that the CEC is enabled. Refer to the televisions user manual if you are not familiar
with the televisions configuration setup menu.
protocol is implemented in most in modern televisions.
Enter the televisions configuration menu using the televisions original remote control unit and
confirm that the CEC is enabled. Refer to the televisions user manual if you are not familiar
with the televisions configuration setup menu.
Please note that different TV manufacturers refer to the CEC protocol using their own ‘Trade
Names’, some examples of ‘Trade Names’ used for the CEC protocol are:
Names’, some examples of ‘Trade Names’ used for the CEC protocol are:
Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Link and BRAVIA
Sync (Sony); HDMI-CEC (Hitachi); E-link (AOC); Kuro Link (Pioneer); CE-Link and Regza Link
(Toshiba); RIHD (Remote Interactive over HDMI) (Onkyo); RuncoLink (Runco International);
SimpLink (LG); HDAVI Control, EZ-Sync, VIERA Link (Panasonic); EasyLink (Philips); and
NetCommand for HDMI (Mitsubishi)
Sync (Sony); HDMI-CEC (Hitachi); E-link (AOC); Kuro Link (Pioneer); CE-Link and Regza Link
(Toshiba); RIHD (Remote Interactive over HDMI) (Onkyo); RuncoLink (Runco International);
SimpLink (LG); HDAVI Control, EZ-Sync, VIERA Link (Panasonic); EasyLink (Philips); and
NetCommand for HDMI (Mitsubishi)
The initial guided procedure
Now that the SBB is connected and powered-up, switch on the television and select the source
connection of the OnAir SBB (normally HDMI1) .
All OnAir SSBs are shipped unconfigured (factory default) and in this initial state will display a
guided setup procedure that must be completed before the SBB can be used.
connection of the OnAir SBB (normally HDMI1) .
All OnAir SSBs are shipped unconfigured (factory default) and in this initial state will display a
guided setup procedure that must be completed before the SBB can be used.
The following chapters will guide you through the setup procedure, the procedure starts with
the pairing request page, shown immediately after the splash screen graphic displayed during
the boot process.
the pairing request page, shown immediately after the splash screen graphic displayed during
the boot process.
1
Once the initial setup procedure has been successfully completed it will not be shown
again. However the SBB can be reset to factory defaults to restart the initial setup
procedure if required. See the troubleshooting chapter for detailed instructions
again. However the SBB can be reset to factory defaults to restart the initial setup
procedure if required. See the troubleshooting chapter for detailed instructions
9