Справочник Пользователя для Linx Technologies 3F090008X
RK-Wi.232FHSS-25-FCC Rapid Development Kit
User’s Manual
© 2002-6 Radiotronix Inc, all rights reserved
- 3 -
3/27/2006
1 Description
The RK-Wi.232FHSS-25-FCC
™ is a rapid-development/evaluation kit, which contains FCC pre-
authorized FCC-Wi.232FHSS-25
™ modules. When used within the guidelines presented in this
document, no FCC part 15 transmitter testing/certification of the FCC-Wi.232FHSS-25
™ is necessary in
the end product.
Included in the kit is:
• 1-Rapid Development Case.
• 1-Rapid Development Utility and Documentation CD.
• 2-Wi.232 Rapid Development Boards.
• 2-FCC-Wi.232FHSS-25™ pinned modules.
• 2-900 MHz antennas.
• 2-RS-232 cables.
• 2-USB cables.
• 6-AAA batteries.
• Startup Guide.
• 1-Rapid Development Utility and Documentation CD.
• 2-Wi.232 Rapid Development Boards.
• 2-FCC-Wi.232FHSS-25™ pinned modules.
• 2-900 MHz antennas.
• 2-RS-232 cables.
• 2-USB cables.
• 6-AAA batteries.
• Startup Guide.
2 RApid Development Kit Setup
• Insert the AAA batteries into the evaluation PCB, observing the correct polarity.
• Insert a FCC-Wi.232FHSS-25™ module into one of the evaluation boards, observing the correct
• Insert a FCC-Wi.232FHSS-25™ module into one of the evaluation boards, observing the correct
orientation (see later in this document). The correct orientation of the module is with the antenna
connector closest to the edge of the evaluation board. Make sure it is seated fully and correctly.
connector closest to the edge of the evaluation board. Make sure it is seated fully and correctly.
• Insert the other FCC-Wi.232FHSS-25™ module into the other evaluation board, also observing
the correct polarity.
• Connect antennas to FCC-Wi.232FHSS-25™ modules.
• Connect evaluation boards to computers. If using USB communications, populate USB jumpers
• Connect evaluation boards to computers. If using USB communications, populate USB jumpers
and remove RS-232 jumpers. If using RS-232 communications, populate RS-232 jumpers and
remove USB jumpers.
remove USB jumpers.
• Install the RK-Wi.232FHSS-FCC™ Windows software. If already installed, skip this step.
• Run the RK-Wi.232FHSS-FCC™ software, select 2400 baud operation and navigate to the
• Run the RK-Wi.232FHSS-FCC™ software, select 2400 baud operation and navigate to the
“Wireless Chat” tab.
• Power-On both evaluation boards, verifying that the version/copyright information is echoed to the
screen from both modules.
• Chat back and forth between evaluation boards, verifying that serial and RF communications are
successful.
•
IMPORTANT NOTE FOR HYPERTERMINAL USERS
: See section 4.1