Справочник Пользователя для SendFar Technology Co. Ltd. OAP-04003
16
3.2.2 Configure the AP as a Router with PPPoE Ethernet
connection
connection
Configure TCP/IP parameters
1. Click Advanced Config, select Bridging, and then click Disable for
Bridge Function as shown in Figure 3-4. After that, click FINISH at the
bottom of this page to complete the modification of this page.
bottom of this page to complete the modification of this page.
2. If you are an ADSL subscriber, you need specify that your personal ISP
PPPoE username and password to enable ADSL broadband access, in
here, click Basic Config, select ISP (as shown in Figure 3-5), In this
page, enter MODIFY button to setup the correct ISP parameters: ISP
Name, ISP Phone, PPPoE Username and PPPoE Password to (as
shown in Figure 3-6).
here, click Basic Config, select ISP (as shown in Figure 3-5), In this
page, enter MODIFY button to setup the correct ISP parameters: ISP
Name, ISP Phone, PPPoE Username and PPPoE Password to (as
shown in Figure 3-6).
Hint: Ask your ISP for the correct settings.
Figure 3-5
17
Figure 3-6
3. Click Basic Config, select Interface (as shown in Figure 3-7) and in
this page, you can click radio button and enter MODIFY to choice which
one that you want to change it (as shown in Figure 3-8).
one that you want to change it (as shown in Figure 3-8).
In interface 1, Make sure this wireless interface status is Active, enter
the Wireless interface IP (default is 192.168.1.1) and Wireless
interface Net Mask (default is 255.255.255.0) that are suitable for your
wireless network.
the Wireless interface IP (default is 192.168.1.1) and Wireless
interface Net Mask (default is 255.255.255.0) that are suitable for your
wireless network.
In interface 2, Make sure this Ethernet interface status is Active, and
specify the Ethernet IP address (default is 192.168.2.1) and Ethernet
Net Mask (default is 255.255.255.0) of the Ethernet interface.
specify the Ethernet IP address (default is 192.168.2.1) and Ethernet
Net Mask (default is 255.255.255.0) of the Ethernet interface.
In interface 3, Make sure this PPPoE interface status is Active, and
specify the Ethernet IP address (default is 192.168.3.1) and Ethernet
Net Mask (default is 255.255.255.0), choice the ISP index that your are
configured in step 1. After that, follow the default setting and Click the OK
button to return to the Interface Parameter window. Finally, you need to
click FINISH at the bottom of this page to complete the modification of
this page.
specify the Ethernet IP address (default is 192.168.3.1) and Ethernet
Net Mask (default is 255.255.255.0), choice the ISP index that your are
configured in step 1. After that, follow the default setting and Click the OK
button to return to the Interface Parameter window. Finally, you need to
click FINISH at the bottom of this page to complete the modification of
this page.