Справочник Пользователя для Controlled Electronic Management Systems Ltd INFOPROX
InfoProx Entry
Configuring the Door Control Unit
Configure Inputs
Note
DO NOT CHANGE FACTORY INPUTS WITHOUT CONSULTING WITH
TECHNICAL SUPPORT.
TECHNICAL SUPPORT.
This screen appears after Config TZ Type.
Config I/Ps
0-Yes, Other-No
0-Yes, Other-No
There are four inputs for the unit: 0 monitors door position; 1 monitors lock status;
2 monitors RTE/RTX switch status and 3 is a spare input. Input configurations are
set at the factory. Generally, these inputs should not be reconfigured and setup
mode should be bypassed by pressing #.
2 monitors RTE/RTX switch status and 3 is a spare input. Input configurations are
set at the factory. Generally, these inputs should not be reconfigured and setup
mode should be bypassed by pressing #.
Doorstrike Time
Door strike is the time a door lock remains open.
After a card has been validated at the reader, the relay controlling the door lock is
activated for the time set in Door Strike Time mode. During this timeframe, the
door can be opened. If the cardholder does not open the door during this time, the
door lock will relock and will not open. The default setting is five seconds.
activated for the time set in Door Strike Time mode. During this timeframe, the
door can be opened. If the cardholder does not open the door during this time, the
door lock will relock and will not open. The default setting is five seconds.
Modifying the door strike time
Pressing # at the end of Configure Inputs displays the following Door Strike
Time prompt:
Time prompt:
Set Drsk= 05s
New Drsk= s
New Drsk= s
1.
Enter a two-digit number for the seconds desired for Door Strike
Time.
Time.
Once the time is set, the next screen in the Configuration menu
sequence, Door Close After Time, automatically displays.
sequence, Door Close After Time, automatically displays.
This option can be bypassed by pressing the # key,
accepting the default setting of five seconds. The
accepting the default setting of five seconds. The
Ù key can
be used to correct any errors entering the Door strike time.
Software House
35