Справочник Пользователя для Saitek Electronics Ltd PS30-1
Installing joystick driver software
Important note: Calibrating your joystick
The Saitek Cyborg evo Wireless stick uses a dynamic auto-calibration system, which is
designed to give you more accurate control. To maximise the effectiveness of
calibration, ensure that the stick is moved fully forwards, backwards and to both sides
after booting up your PC and before loading up your game.
designed to give you more accurate control. To maximise the effectiveness of
calibration, ensure that the stick is moved fully forwards, backwards and to both sides
after booting up your PC and before loading up your game.
Installation for users of Windows® XP
a) Drivers only for typical users
The software on the CD supplied with this product has been thoroughly tested and
complies with all Microsoft standards. However, we recommend that prior to installing
any 3rd party software you create a restore point to return to should you encounter any
difficulties.
complies with all Microsoft standards. However, we recommend that prior to installing
any 3rd party software you create a restore point to return to should you encounter any
difficulties.
Windows®XP users can do this by clicking on Start followed by Programs, then
Accessories, System Tools and finally on System Restore. In the window that
appears select Create a restore point and then click on Next. You will be prompted to
supply a name for this set-up.
Accessories, System Tools and finally on System Restore. In the window that
appears select Create a restore point and then click on Next. You will be prompted to
supply a name for this set-up.
Should you then encounter any difficulties during the installation process you can follow
the same path to restore your PC to its pre-installed state.
the same path to restore your PC to its pre-installed state.
1 With your computer switched on, close down any programs that are currently running
and insert the Saitek Smart Technology CD into your CD-ROM drive.
2 When the Introduction Screen appears, click Install Software to continue.
3 When the Welcome screen appears, click Next to continue. (If the CD does not run
automatically, select Start from the Windows® Taskbar, then Run and type
D:\Setup.exe and click OK - where D:\ is letter of your CD-ROM drive).
D:\Setup.exe and click OK - where D:\ is letter of your CD-ROM drive).
4 After reading the Disclaimer, select the I accept the terms of the Disclaimer option
and click Next to continue.
5 At the Driver Setup screen, plug in your wireless receiver dongle and click on Next.
6 At the Driver Setup screen, click Next to test your controller.
7 When the Saitek Controller screen appears, try out all your controller’s buttons and
controls to show that it is working properly. When you have finished, click OK.
8 At the Software Setup screen, select Do not install the SST Programming
Software and click Next. The Programming Software can be installed at a later date
by following instruction (b) below
by following instruction (b) below