Справочник Пользователя для Saitek Electronics Ltd PS30-1

9    At the Registration screen, select Check this box to register now and follow the 

on-screen instructions, or you can choose to select this option later.  

10  Click on Finish to complete the installation.  

 

1    Follow points 1 – 7 of the install procedure in A), then at the Software Setup screen, 

select Install the SST Programming Software and click Next. 

2    In the following Software Setup screen, click Next and follow the on-screen 

instructions. At this point you will be asked to install such features as the Saitek 
Magic Mouse, HID-compliant mouse, Saitek Magic Keyboard and HID Keyboard 
Device (these are what XP calls the various elements of your Saitek controller). 
Continue to click on Next and Finish to accept the installation until the Registration 
screen appears.  

3    At the Registration screen, select Check this box to register now and follow the 

on-screen instructions, or do not select this option and register later. 

4    Upon completion of the installation, you have the option to Run Profile Editor, which 

will give you a view of the 3D programming environment. If you do not wish to see 
the Profile Editor at this point, just uncheck the box and click on Finish to complete 
the installation.  

 

1    With your computer switched on, close down any programs that are currently running 

and insert the Saitek Smart Technology CD into your CD-ROM drive. 

2    When the Introduction Screen appears, click Install Software to continue. 

3    When the Welcome screen appears, click Next to continue. (If the CD does not run 

automatically, select Start from the Windows® Taskbar, then Run and type 
D:\Setup.exe and click OK - where D:\ is letter of your CD-ROM drive).  

4    After reading the Disclaimer, select the I accept the terms of the Disclaimer option 

and click Next to continue. 

5    At the Device Driver Installation screen, click on Next and follow the on-screen 

instructions.  

6    When prompted, plug your controller’s USB connector into your computer, then click 

on Configure.  

7    When the Controller Properties screen appears, click Next to view the Test screen.