Справочник Пользователя для Savi Technology Inc 600SP-V1
0RXQWLQJWKH6LJQSRVWV
(FKR3RLQW6LJQSRVW,QVWDOODWLRQ*XLGH
&DEOLQJWKH0RGHO636LJQSRVW
The only cabling required for a basic installation is operating power.
This needs to be done in accordance with applicable safety
regulations. All cables should be routed and protected in a manner
which precludes damage to them or harm to personnel; for example,
unsecured extension cords left across access-ways or where assets or
asset moving equipment can damage them.
This needs to be done in accordance with applicable safety
regulations. All cables should be routed and protected in a manner
which precludes damage to them or harm to personnel; for example,
unsecured extension cords left across access-ways or where assets or
asset moving equipment can damage them.
This section does not include connecting the Signpost to a computer
with a serial cable for Signpost software configuration. That activity
is covered in Chapter 3, “Signpost Configuration.”
with a serial cable for Signpost software configuration. That activity
is covered in Chapter 3, “Signpost Configuration.”
The connectors and LED shown in Table 2-3 are available on a Model
SP-600-201 Signpost.
SP-600-201 Signpost.
7DEOH
0RGHO636LJQSRVW&RQQHFWRUVDQG/('V
Connectors
and LEDs
and LEDs
Description
Power
The input power is connected here.
RS-232
Used to connect to a computer for setup and diagnostics by installers
and technicians.
and technicians.
Antenna
The external loop antenna connects here
Sync In
Used to synchronize 2 to 4 Model SP-600-201 Signposts to cover an
area larger than is possible with a single Signpost.This connector can
also accept DC volts from another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
area larger than is possible with a single Signpost.This connector can
also accept DC volts from another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
Sync Out
Used to synchronize 2 to 4 Model SP-600-201 Signposts to cover an
area larger than is possible with a single Signpost. This connector can
also output DC volts to another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
area larger than is possible with a single Signpost. This connector can
also output DC volts to another Signpost to avoid running separate
power lines when two or more Signposts are synchronized
Sensor 1
A closure on these two pins will trigger a predefined Signpost action.
Sensor 2
A closure on these two pins will trigger a predefined Signpost action.
Status
This LED indicates when power is applied and the Signpost mode of
operation:
operation:
On ½ second, off ½ second indicates normal operation
On 1 second, off 1 second indicates the Signpost is off but powered
On continuously indicates the Signpost is transmitting a CW signal