Справочник Пользователя для AeroComm Corporation 2510100
LAIRD TECHNOLOGIES www.lairdtech.com
C
OMPLIANCY
I
NFORMATION
10
A G E N C Y I D E N T I F I C A T I O N N U M B E R S
A P P R O V E D A N T E N N A L I S T
The following antennas are approved for operation with the LT2510 as identified. .
This device has been designed to operate with the antennas listed below, and having a maximum gain of 6dB when hopping over
43 hop bins and 9dB when hopping over 79 hop bins.. Antennas not included in this list or having a gain greater than the maximum
allowed are strictly prohibited for use with this device. The required antenna impedance is 50 Ohms.
43 hop bins and 9dB when hopping over 79 hop bins.. Antennas not included in this list or having a gain greater than the maximum
allowed are strictly prohibited for use with this device. The required antenna impedance is 50 Ohms.
F C C / I C R E Q U I R E M E N T S F O R M O D U L A R A P P R O V A L
In general, there are two agency classifications of wireless applications; portable and mobile.
Portable - Portable is a classification of equipment where the user, in general, will be within 20 cm of the transmitting antenna.
Portable equipment is further broken down into two classes; within 2.5 cm of human contact and beyond 2.5 cm. The LT2510 is
not agency approved for portable applications. The OEM is required to have additional testing performed to receive this
classification. Contact Laird Technology for more details.
Portable equipment is further broken down into two classes; within 2.5 cm of human contact and beyond 2.5 cm. The LT2510 is
not agency approved for portable applications. The OEM is required to have additional testing performed to receive this
classification. Contact Laird Technology for more details.
Mobile - Mobile defines equipment where the user will be 20 cm or greater from the transmitting equipment. The antenna must be
Ta b l e 1 1 : A g e n c y I d e n t i f i c a t i o n N u m b e r s
Part Number
US/FCC
CANADA/IC
ETSI
LT2510
KQL-2510100
2268C-2510100
Pending
Ta b l e 1 2 : LT 2 5 1 0 A p p r o v e d A n t e n n a L i s t
1
1.
The OEM is free to choose another vendor’s antenna of like type and equal or lesser gain as an antenna
appearing in the table and still maintain compliance
appearing in the table and still maintain compliance
Laird Technology Part
Number
Manufacturer Part
Number
Manufacturer
Type
Gain
(dBi)
WIC2450-A
Laird
Chip
2
IG2450-RS36
Laird Technologies
Omni
6
ID2450-RS36
2
2. To comply with the power requirements of 15.247(b)(1) and 15.247(b)(4), the module cannot be used with the 9dBi antenna if
using the 43 channel hop sequence and full power. The module must either hop over the full 79 channels or the power setting
must be turned down to 0x01 or lower.
must be turned down to 0x01 or lower.
Laird Technologies
Panel
9
S151FC-L-(132)PX-2450S
Nearson
Dipole
5