Справочник Пользователя для AeroComm Corporation 2510100

mounted in such a way that it cannot be moved closer to the user with respect to the equipment, although the equipment may be
moved.

This equipment has been approved for mobile applications where the equipment should be used at distances greater than 20cm
from the human body.  Operation at distances of less than 20cm would require additional RF exposure evaluation, including SAR
requirement according to FCC RF exporsure guideline.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.

•

Consult the dealer or an experienced radio/TV technician for help.

WARNING: The OEM must ensure that FCC labeling requirements are met. This includes a clearly visible label on the outside of
the OEM enclosure specifying the appropriate Laird Technology FCC identifier for this product as well as the FCC notice below.
The FCC identifiers are listed above.

Label and text information should be in a size of type large enough to be readily legible, consistent with the dimensions of the
equipment and the label. However, the type size for the text is not required to be larger than eight point.

To reduce potential radio interference to other users, the antenna type and gain should be chosen so that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.

WARNING: This device has been tested with a U.FL connector with the above listed antennas. When integrated into the OEM’s
product, these fixed antennas require professional installation preventing end-users from replacing them with non-approved
antennas. Any antenna not listed in the above table must be tested to comply with FCC Section 15.203 for unique antenna
connectors and Section 15.247 for emissions. Contact Laird Technology for assistance.

Caution: Any changes or modifications not expressly approved by Laird Technology could void the user’s authority to operate the
equipment.