Справочник Пользователя для Continental Conair Limited GH5811
Prepare By: Dreamis So
P.14
29/3/2004
Wall Mounting
THE GH5850/5852 CAN BE MOUNTED ON A STANDARD WALL PHONE
PLATE. IF ONE IS NOT AVAILABLE, IT CAN ALSO BE MOUNTED ON TWO
SCREWS (NOT INCLUDED), INSTALLED 3-1/4” APART VERTICALLY IN THE
WALL. LEAVE 3/16” OF EACH SCREW EXPOSED FOR MOUNTING THE UNIT.
A. Connect the wall mount stand to the bottom of the base in the wall mount
THE GH5850/5852 CAN BE MOUNTED ON A STANDARD WALL PHONE
PLATE. IF ONE IS NOT AVAILABLE, IT CAN ALSO BE MOUNTED ON TWO
SCREWS (NOT INCLUDED), INSTALLED 3-1/4” APART VERTICALLY IN THE
WALL. LEAVE 3/16” OF EACH SCREW EXPOSED FOR MOUNTING THE UNIT.
A. Connect the wall mount stand to the bottom of the base in the wall mount
position. You can remove the bracket from the base by pushing on the bracket
tab.
tab.
B. Place one end of the short telephone line cord into the modular jack marked
TEL.LINE located at the back of the base.
C. Place the other end of the line cord into the recessed area in the bottom of the
wall mount stand, and plug into the telephone wall jack.
D. Connect the DC adaptor into the back of the unit and plug the other end to the
110/120 volt AC outlet.
E. Position the wall mount slots on the bottom of the bracket over the two studs
on the wall plate. Pull down and lock into place.
F. Place the handset into the base. Make sure that the handset guide (on the
base) fits securely into the slot underneath the handset earpiece. The
CHARGE LED will light. The LCD should display “Charging” for 2 minutes and
then return to standby mode display. During these 2 minutes, user can pick up
the phone and operate it in standby mode.
CHARGE LED will light. The LCD should display “Charging” for 2 minutes and
then return to standby mode display. During these 2 minutes, user can pick up
the phone and operate it in standby mode.
Handset Battery Charging
The battery pack in the handset must be fully charged for about 16 hours before
using the telephone.
Note:
a. When the battery gets low, there will be a low-battery beep from the handset.
The handset will display “LOW BATTERY” on the second line of the LCD.
b. If the battery becomes low while you are on a call terminate the call quickly
and put handset in the base to recharge the battery.
c. Remember to plug in the battery adaptor. Otherwise, there will be no
response.
d. The battery will hold its charge for several days out of the cradle, depending
on use.
To Replace Batteries
1. Remove battery cover
2. Remove old battery
3. Install new battery
4. Close battery cover.
5. Place the handset on the base unit. In the first 2 minutes, the LCD will
2. Remove old battery
3. Install new battery
4. Close battery cover.
5. Place the handset on the base unit. In the first 2 minutes, the LCD will
display initialization in first time uses.
C
H A R
G
I N
G
. . .
6. Then, the display will change as follows after 2 minutes buffer: