Справочник Пользователя для Honeywell International Inc. 99EXLF

17 - 3

The charger must be connected to a power source via the Honeywell power adapter cable so that volt-
age is adjusted appropriately. Use only UL Listed power supply, which has been qualified by Honeywell 
with output rated at 12VDC and 3 amps with the device.

1.

Locate the AC power adapter cable and plug it into the power source. 

2.

Connect the power cable to the power adapter.

3.

Connect the power cable to the supply connector on the back of the charger. 

4.

The power LED illuminates green, and the charger performs a self-diagnostic test that lasts 
approximately five seconds.

To maintain top performance from batteries, avoid storing batteries outside of the following temperature 
ranges:

• 14°F to 113°F (-10°C to +45°C) for short term storage of less than one month
• 32°F to 86°F (-0°C to +30°C) for long term storage   

Do not store batteries in extremely high humidity. For prolonged storage, do not keep batteries stored in 
a charger that is connected to a power source. 

For best results, battery packs should be at room temperature before recharging them; temperature has 
a marked effect on charging. The recommended temperature range is 50°F to 95° F (10

°

C to 35

°

 C). 

1.

2.

Power the charger. The Power LED illuminates green.

3.

Insert the battery at an angle so the battery pack contacts 
and the QuadCharger contacts align.

4.

Snap the battery into place with a hinging motion. 

5.

The Status LED for that particular slot illuminates orange to 
indicate the battery is seated properly and the charging cycle has begun. 

6.

When the Status LED turns green, the battery in the slot has completed charging.

Power Supply 
Connector

Power LED