Справочник Пользователя для Rohde & Schwarz Inc SLV8000
Chapter 5
Operating
2100.4400.32
- 5.70 -
E-2
7
DVB Settings: TV Settings > DVB Menu
The menu windows in the TV Settings > DVB menu are used to (pre)set the DVB trans-
mission parameters required for coding and modulation and to check the used (TPS) set-
tings (TPS = Transmission Parameter Signaling) which are signaled during transmission.
mission parameters required for coding and modulation and to check the used (TPS) set-
tings (TPS = Transmission Parameter Signaling) which are signaled during transmission.
Note
Providing there is a MIP (Megaframe Initialization Packet) in the transport stream, TPS in-
formation can also be read out and used for configuring the DVB transmission parameters.
In this case the signaled parameters may not be the same as the manually preset param-
eters.
formation can also be read out and used for configuring the DVB transmission parameters.
In this case the signaled parameters may not be the same as the manually preset param-
eters.
Menu windows
The TV Settings > DVB menu branches to the following menu windows and menu paths:
– Common: Used to select the digital TV standard, the network operating mode and the
TPS source, to switch Tx Automatic on and off, to signal the cell ID in the TPS, and to
set the Tx address
set the Tx address
– TPS: Used to select the TPS source, to enter (pre)settings manually; displays the active
TPS parameters
– SFN Delay: For displaying and setting signal delay times in the SFN
– Test Signals: Used to configure DVB transmission parameters for test mode
– Test Signals: Used to configure DVB transmission parameters for test mode
7.1
TV Settings > DVB > Common
Setting item
Explanation
Digital Standard
Used to select the digital TV standard: DVB-T or DVB-H
Network Mode
Used to select the network operating mode: SFN or MFN
TPS Source
Used to set the source for the TPS parameters: MIP or manual presets
The TPS source can also be set in the TV Settings > DVB > TPS menu
window.
window.
Cell ID Enable
Used to switch cell ID signaling on or off in the TPS
The cell ID itself is set in the TV Settings > DVB > TPS menu window. It
can also be retrieved from the MIP.
can also be retrieved from the MIP.
The Cell ID can only be retrieved from the MIP if Tx Automatic is acti-
vated and the Tx address is correctly set.
vated and the Tx address is correctly set.