Справочник Пользователя для Rohde & Schwarz Inc SLV8000

2100.4400.32

- 5.106 -

E-2

– Transmitter: Used to select the TV standard, to activate message suppression for the

parallel remote interface, to determine the behavior of the parallel remote interface when
switching between analog TV and digital TV, to activate the time scheduler for multistan-
dard operation and to enter the transmitter name

– Configuration: Used to select and configure the TV standards for time-controlled

switchover

– Time Scheduler: Used to define switching times for time-controlled switchover of the

standards

The System Setup > Tx Type > Transmitter menu window is used among other things to
set the input interfaces and signal processing the appropriate TV standard. You can also
activate a time scheduler for multi-standard operating mode and enter special settings for
the parallel remote control interface.

Tx Type

Used to select the TV standard: ATV, DVB or ATSC

The instrument is rebooted automatically when the TV standard is 
changed. Signal processing is also switched over.

Reset On Program 
Off

In the ON switch position, a Reset Fault is automatically triggered when 
the RF output is locked.

Time Scheduler

Used to switch time-controlled tasks planned using the time scheduler 
on and off

Par I/O DTV setting

The parallel remote interface can be used to switch from ATV to DTV. 
The switch determines which standard is used for DTV.

Par I/O Inhibit Status

Used to switch message suppression for the parallel remote interface on 
and off

– OFF: Message suppression is not activated; messages carried by the 

parallel remote interface are also output in local mode

– ON: Message suppression is activated; in local mode, no messages 

are output via the parallel remote interface

Tx Name

Used to enter a transmitter name to make identification easier