Справочник Пользователя для Rohde & Schwarz Inc SLV8000

Chapter 4

Commissioning

2100.4400.32

- 4.10 -

E-2

2.2.2.4

Configuring Input Interfaces and Automatic Input Selection

Setting signal source and data format for transport streams

1. Select TV Settings > Input > Input Config.

The Input Config window opens.

2. Under Source 1, set the signal source for transport stream 1:

a) Select BNC if transport stream 1 is fed via the instrument socket for

TS1

b) Select Rx if transport stream 1 comes from the internal receiver module (DVB-T/-H

receiver option).

3. Under TS Format 1, select the data format for transport stream 1. If AUTO is selected,

the data format is detected automatically.

Note

With hierarchy, the first signal source supplies the HP stream.

4. If necessary (signal standby, LP stream with hierarchy), configure a second transport

stream accordingly under Source 2 and TS Format 2.

Note

Transport stream 2 can be fed via either the instrument socket for

TS2

or a (second) op-

tional receiver module.

Setting automatic input switchover (not with hierarchy)

The following settings are used to preselect the operating input and to configure the behav-
ior of the automatic input switchover.

Setting item

Explanation

Static Delay

Positive or negative offset (set manually for the individual transmitter
location) of the time of transmission relative to the regular time of trans-
mission preset under Maximum Delay. The Static Delay is used to com-
pensate differences between transmission systems from different
manufacturers.

If Static Delay and Tx Offset Delay are present at the same time, their
effect is added together.

Max Deviation Time

Maximum deviation in the calculated time of transmission which can be
corrected without interrupting transmission.
Default setting: 10

s