Справочник Пользователя для Honeywell International Inc. REM1000R01
Wireless Vent and Filter Boost Remote
® U.S. Registered Trademark.
Copyright © 2011 Honeywell International Inc.
All rights reserved.
Copyright © 2011 Honeywell International Inc.
All rights reserved.
Installation
Guide
Guide
20/40/60 Minute Ventilation and Filtration Timer
Install Battery
1 Remove the cover.
2 Insert the CR2450 coin cell battery (included) into the
2 Insert the CR2450 coin cell battery (included) into the
slot at the bottom of the remote. See polarity marking
on the remote.
on the remote.
3 The LED will briefly flash green.
When battery power is low, the LED will flash red.
Mounting
Mounting the remote is optional.
1 Remove the front cover from the remote.
2 Use provided screws and wall anchors to fasten the
2 Use provided screws and wall anchors to fasten the
remote to the wall.
3 Replace the cover on the remote.
Connect
1 Prepare the thermostat for RedLINK connection (see
the thermostat or EIM instructions).
2 Press and release the CONNECT button on the
remote. After a short delay, the LED will glow green for 15 seconds.
• Ventilation and filtration control from any
location.
• Works with any RedLINK® 2.0 thermostat.
• Does not require a ventilator to boost
filtration.
M33096
M33095
69-2677EFS-03