Справочник Пользователя для ZyXEL Communications Corporation PLA4231
Chapter 3 The RESET/ENCRYPT Button
PLA4231 User’s Guide
16
2
Press the RESET/ENCRYPT button at the side of your powerline device for 0.5 to 3 seconds. The
power (
power (
) light will blink as the powerline device tries to set up a connection.
Figure 2
ENCRYPT Connection Procedure
Note: The RESET/ENCRYPT button’s location varies for each Powerline model.
3
in this section for the other powerline device you wish to connect. This must be done
within 120 seconds of pressing the RESET/ENCRYPT button on the PLA4231.
Note: Check the lights on the two powerline devices. The power (
) and HomePlug (
)
lights should be blinking while the devices are connecting. Several times all lights
blink simultaneously and the HomePlug (
) light also shows red. Wait for about
one minute while your powerline devices connect.
If the power (
) light does not blink when you press RESET/ENCRYPT, you have probably
pressed the RESET/ENCRYPT button for too long. Try again, pressing the RESET/
ENCRYPT button for 0.5 to 3 seconds.
If the HomePlug (
) lights on both powerline devices do not light up, the powerline
devices are not connected. Repeat steps 2 and 3 in this section. If that doesn’t work, see
the Troubleshooting in Section 14.5 on page 99 for suggestions.
4
To add more powerline devices to your network, press and hold the RESET/ENCRYPT button on
device C (shown below) for for 5 to 8 seconds and then release it.
device C (shown below) for for 5 to 8 seconds and then release it.
press 0.5 ~ 3 seconds
press 0.5 ~ 3 seconds
within 2
minutes