Справочник Пользователя для Garmin International Inc 03164
3
Place the rubber pad around the
bar:
• If the bar diameter is
• If the bar diameter is
25.4 mm, use the thicker pad.
• If the bar diameter is
31.8 mm, use the thinner pad.
4
Place the bar connector around
the rubber pad.
5
Replace and tighten the screw.
NOTE: Garmin
NOTE: Garmin
®
recommends a torque
specification of 7 lbf-in. (0.8 N-m). You
should check the tightness of the
screw periodically.
6
Align the tabs on the back of the
device with the mount notches
Â
.
7
Press down slightly and turn the
device clockwise until it locks into
place.
8VLQJ WKH GHYLFH
If your device was packaged with an
ANT+
®
sensor, they are already paired and
can be activated during initial setup.
1
Hold
to turn on the device.
2
Go outside, and wait while the device
locates satellites.
The satellite bars turn green when the
The satellite bars turn green when the
device is ready.
3
From the home screen, select .
4
Select to start the activity timer.
Quick Start Manual
5