Справочник Пользователя для Selex Sistemi Integrati Inc. VOR2
Model 1150A DVOR
3-26
Rev. - November, 2008
This document contains proprietary information and such information may not be disclosed
to others for any purposes without written permission from SELEX Sistemi Integrati Inc.
3.6.7.4.2
Station Configuration Screen
. This screen is used to configure the various system-level
parameters for the VOR station: CVOR/DVOR, Dual/Single Transmitter Dual/Single Monitors, Dual Monitor
Inputs, and the station’s Transmitter Frequency. The value for each of these settings currently stored in the RMS,
Monitors, and Audio Generators is also displayed for reference. Note that any changes under User Configuration
must be made while in the “Local” mode and will not take effect until the “Apply” button is pressed. The “Apply”
button is “grayed” out until a parameter is changed and then becomes fully visible.
Any discrepancies between the User Configuration, RMS, Monitors, or Audio Generators will be indicated with a
red background, and should be corrected by the user. This can be done by verifying the backplane DIP switch
settings as detailed below, backing up the configuration (RMS >> Config Backup) followed by a system reset.
Inputs, and the station’s Transmitter Frequency. The value for each of these settings currently stored in the RMS,
Monitors, and Audio Generators is also displayed for reference. Note that any changes under User Configuration
must be made while in the “Local” mode and will not take effect until the “Apply” button is pressed. The “Apply”
button is “grayed” out until a parameter is changed and then becomes fully visible.
Any discrepancies between the User Configuration, RMS, Monitors, or Audio Generators will be indicated with a
red background, and should be corrected by the user. This can be done by verifying the backplane DIP switch
settings as detailed below, backing up the configuration (RMS >> Config Backup) followed by a system reset.
Figure 3-21 Station Configuration Screen