Справочник Пользователя для HID Global Corporation X001800C

© 

2010 

HID 

Global 

Corporation 

 

       All 

rights 

reserved 

 

This is factory set. If the main board or the Printhead is 
replaced then adjust this number.  

Locate the Printhead Setting Number on the bottom of the 
Printhead.  

The number reads R=XXXX.  

This is a calibration driven value and should not be 
adjusted. If the Printhead assembly is replaced then this 
value may need to be adjusted. 

(Note:  This is factory set and should not be changed 
unless directed by a technician.) 

This is a calibration driven value and should not be 
adjusted. If the Printhead assembly is replaced then this 
value may need to be adjusted. 

(Note:  This is factory set and should not be changed 
unless directed by a technician.) 

Adjust the Erase temperature for the rewriteable cards as 
needed. 

• Increase the Current Setting to cause more heat to 

be used in the erasing process. 

• Decrease the Current Setting to cause less heat to be 

used in the erasing process. 

(Note:  Erase Temp Offset provides user ability to control 
the Printhead heat level when the Erase Operation is 
performed. Appropriate heat levels should be applied for 
the proper erase process. This setting should be adjusted 
for proper erasure.) 

DTC4500 Card Printer/Encoder User Guide

 

44