HID Global Corporation X001800C 用户手册
©
2010
HID
Global
Corporation
All
rights
reserved
Selecting the Advanced Settings tab
Setting
Option
Head Resistance
This is factory set. If the main board or the Printhead is
replaced then adjust this number.
replaced then adjust this number.
Locate the Printhead Setting Number on the bottom of the
Printhead.
Printhead.
The number reads R=XXXX.
Head Home Offset
This is a calibration driven value and should not be
adjusted. If the Printhead assembly is replaced then this
value may need to be adjusted.
adjusted. If the Printhead assembly is replaced then this
value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
unless directed by a technician.)
Head Contact Offset
This is a calibration driven value and should not be
adjusted. If the Printhead assembly is replaced then this
value may need to be adjusted.
adjusted. If the Printhead assembly is replaced then this
value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
unless directed by a technician.)
Erase Heat Offset
Adjust the Erase temperature for the rewriteable cards as
needed.
needed.
• Increase the Current Setting to cause more heat to
be used in the erasing process.
OR
• Decrease the Current Setting to cause less heat to be
used in the erasing process.
(Note: Erase Temp Offset provides user ability to control
the Printhead heat level when the Erase Operation is
performed. Appropriate heat levels should be applied for
the proper erase process. This setting should be adjusted
for proper erasure.)
the Printhead heat level when the Erase Operation is
performed. Appropriate heat levels should be applied for
the proper erase process. This setting should be adjusted
for proper erasure.)
DTC4500 Card Printer/Encoder User Guide
44