Справочник Пользователя для CALAMP WIRELESS NETWORKS INC. BDD4T83-2

The BDLC

PD

 assembly uses a standard 120 VAC

power cord. Plug this cord to the rear power out-
let shown in Figure 4 and Figure 5.

To check or install a fuse:

1.  Open the slide-out fuse drawer located below

the power connector by using a fine bladed
screwdriver or a knife blade and gently pry
open.

2.  Hold the fuse support in one hand and with

the other, lift the center plastic retainer until
it releases the fuse sliding base.

3.  Replace or install a 250V, 2A fuse.

4.  To complete the procedure, push the sliding

fuse base until it snaps under the retainer.

5.  Re-insert the fuse drawer in its housing and

push until it is fully seated and closed.

When ready to apply power, use the ON-OFF
toggle power switch adjacent to the power con-
nector.

Paragon

PD

 commonly uses three antennas (one

transmit and two receive) unless a duplexer is
used with one of the receive antennas; then only
two antennas would be needed. They should be
mounted according to any guidelines supplied
with the antennas. For antennas placement and
spacing, consult System Engineering.

1-  Route good quality 50-ohm double-shielded

coaxial cable(s) (e.g. RG-214 or Heliax) from
the selected antenna position(s) to the Para-
gon

PD

 Radio assembly.

2-  Terminate the RX-1 and RX-2 cable ends at

the Receiver modules rear position with an
N-type connector.

3-  Similarly, terminate the TX cable end at the

Power Amp’s module rear position with an
N-type connector.

Paragon

PD

 products are factory-configured to

user’s requirements and are shipped ready to run.

After new installations:

•

  Re-check that all connections are secure on

radio and BDLC

PD

 assemblies (antennas, PC,

power cords etc.)

•

  Check that fuses are inserted.

•

  Turn both BDLC

PD

 and radio power ON.

You are now ready to check for normal operation
(as per paragraph 2.6) and to run the Dataradio
Windows Radio Installation Software (WinRIS)
program for testing or trouble-shooting.

Any change(s) to the settings must be done via
files saved on diskette and loaded into the unit
using the WinRIS program.

Employer u niquement  av ec

un  fusible de 250 V

Use only with  a  250 V fuse

ON-OFF

Switch

120VAC

Connector

Fuse

Slide-out

Drawer