Справочник Пользователя для Elster Solutions LLC SRP03
CHAPTER
3
SRP
O
PERATION
Short Range Programmer VRT—User Guide
Page 11
P/N 52806T100 Rev 1 April 2003
•
AMCO Automated Systems
Using Read Meter Index Mode
This mode reads the meter index (meter count). It will display whole units
only. (For pre-divider/sub-count values use Read Pre-divider mode.)
1. Press the MODE button repeatedly until the display shows the “Enter
Read Meter Index” screen.
2. Acquire the transponder serial number.
• Acquire serial number either: (a) by using the Find mode first or
(b) by manually entering the serial number in this mode.
3.
Press one of the two INT (interrogate) buttons.
• If the interrogation is successful, the SRP will display the
transponder serial number, the current meter index value and the
tamper indicator, if applicable (as shown below):
tamper indicator, if applicable (as shown below):
• Any TAMPER indication that appears will not appear again on
the next interrogation. (Tampers are automatically “cleared” after
interrogation.)
interrogation.)
• If the interrogation is NOT successful, the screen will display the
“CARRIER NOT DETECTED” message (indicating no signal
from transponder) or “RECEIVE DATA ERROR” (indicating radio
signal interference). These messages display for 2 seconds,
during which time the SRP will not interrogate..
from transponder) or “RECEIVE DATA ERROR” (indicating radio
signal interference). These messages display for 2 seconds,
during which time the SRP will not interrogate..
4. If the interrogation is NOT successful, move the SRP to a slightly
different position relative to the transponder (closer, farther away, or
to one side) and interrogate again.
to one side) and interrogate again.
• Radio waves can bounce off of, or be absorbed or deflected by,
various materials (especially metals) which can create slight
differences in signal strength from one spot to another.
differences in signal strength from one spot to another.
READ METER INDEX
Serial No.. ???????
READ METER INDEX
Serial No.. ???????
INDEX NO.. 00001234
TAMPER