Справочник Пользователя для Lectrosonics Inc D4T

8

System Setup Steps

The following steps are necessary to set up and oper-

ate the D4 system. Details for each step are on the 

next pages.

1)  Attach antennas and power supplies to the trans-

mitter and receiver.

2)  Tuning Menu - select the same operating frequen-

cy on the transmitter and receiver.

3)  2/4 Channel Mode - set 2-channel or 4-channel

modes the same on transmitter and receiver.

4)  Select the AES3 modes on transmitter and receiv-

er as needed for the connected equipment, mixer, 

recorder, etc. (see AES3 Modes)

5)  Adjust audio input levels on the transmitter. (see

Transmitter Audio Level Setup)

6)  Adjust audio output levels of analog outputs on the

receiver. (see Receiver Audio Level Setup)

7)  Walk test the system to check for adequate op-

erating range. If dropouts occur within the range 

needed, select a different operating frequency.

System Setup

Tuning Menu

 

 

2/4 Channel Modes

 

 

 

 

AES3 Modes

 

 

 

 

 

 

Audio Level

NOTE:  The setup screens for Audio Level on the 

transmitter and receiver will be slightly different. 

See the next page for details.

Locked/Unlocked Modes