Справочник Пользователя для Lectrosonics Inc LMBC1

Digital Hybrid Wireless Belt-Pack Transmitter

Rio Rancho, NM

5

Battery Installation

The transmitter is powered by two AA batteries. We 
recommend using alkaline, lithium, or rechargeable 
batteries for longest life. Standard zinc-carbon batteries 
marked “heavy-duty” or “long-lasting” are not adequate.

The battery status circuitry compensates for the differ-
ence in voltage drop between alkaline and lithium bat-
teries across their usable life, so it’s important to select 
the correct battery type in the menu.

Because rechargeable batteries run down quite abrupt-
ly, using the Power LED to verify battery status will not 
be reliable. However, it is possible to track battery status 
using the Battery Timer function available in Lectroson-
ics Digital Hybrid Wireless

®

 receivers.

Push outward on the Battery Compartment Door and lift 
it to open.

Insert the batteries according to the markings inside the 
battery compartment.

If the batteries are inserted incorrectly, the door will 

close but the unit will not operate.

The battery contacts can be cleaned with alcohol and 
a cotton swab, or a clean pencil eraser. Be sure not 
to leave any remnants of the cotton swab or eraser 
crumbs inside the compartment.

Belt Clips

The wire belt clip may be removed by pulling the ends 
out of the holes in the sides of the case. Use pliers to 
grasp the wire and avoid scratching the surface of the 
housing. Pliers also help when installing the clip.

An optional spring-loaded, hinged belt clip (model num-
ber BCSLEBN) is also available. This clip is attached by 
removing the plastic hole cap on the back of the hous-
ing and mounting the clip with the supplied screw.