Справочник Пользователя для Sennheiser Electronic Corp G3SKMEM
18
Adjusting settings via the operating menu
When you are in the “
Tune
” menu item, the RF signal is deactivated.
Via the “
Tune
” menu item, you can set a transmission frequency to be
stored in the current channel
or
you can select a different channel in one
of the frequency banks “
U1
” to “
U6
” and assign this channel a transmis-
sion frequency. It is vital to observe the notes on frequency selection on
page 20.
page 20.
Setting a transmission frequency for the current channel
Set the desired frequency.
Selecting a channel and assigning this channel a frequency
Set the desired frequency bank and the desired channel.
Set the desired frequency.
Adjusting the transmission power – “RF Power”
Via the “
RF Power
” menu item, you can adjust the transmission power in
two steps. It is vital to observe the notes on the supplied frequency infor-
mation sheet!
mation sheet!
Move the multi-function switch until the “
Tune
” menu item
appears.
Press the multi-function switch.
The frequency selection appears.
The frequency selection appears.
Press the multi-function switch.
Your settings are stored. You are back to the operating menu.
Your settings are stored. You are back to the operating menu.
Move the multi-function switch until the “
Tune
” menu item
appears.
Press the multi-function switch until the frequency bank
selection appears.
selection appears.
Press the multi-function switch.
The frequency selection appears.
The frequency selection appears.
Select the MHz
value and confirm
value and confirm
Select the kHz
value; store the
setting
value; store the
setting
543
.200 MHz
Tu n e
544.
200
MHz
B.Ch: 21.1
B.Ch: 21.1
Tu n e
Call up “Tune”
Advanced
Menu
Tune
“Stored”
543.200 MHz
Select the frequency
bank and confirm
bank and confirm
Select the channel;
store the setting
store the setting
Tu n e
B.Ch:
U1
. 1
B.Ch: U1.
1
Tu n e
Call up “Tune”
(special function)
(special function)
Advanced
Menu
Tune
“Stored”
543.200 MHz
543.200 MHz
543.200 MHz
Call up
“RF Power”
“RF Power”
Select the desired
setting
setting
Store the setting
Advanced
Menu
RF Power
Standard
Standard
RF Power
Low
RF Power
“Stored”
ew G3 SKM 500_529673_0109_SP8_PRT.book Seite 18 Dienstag, 10. Februar 2009 11:20 11