Справочник Пользователя для Telrad Networks Ltd COMPACT2X
Chapter 2 - CommissioningActivating the Unit
Chapter 2: Commissioning
Activating the Unit
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BreezeCOMPACT System Manual
BreezeCOMPACT System Manual
41
The new BS is added to the list of BSs available in the BS node.
2
Select the BS and configure the following parameters. For some parameters, you may use the default value/option:
In Radio > Basic > General:
Idle Mode Enable: Mark the checkbox to enable Idle Mode. By default, Idle Mode is disabled (not checked).£
Paging Group ID: Applicable only if Idle Mode is enabled. The default is 0, which must be changed. The
Paging Group ID should be unique in the Radio Access Network.
Click Apply.
In Radio > Basic > Air Frame Structure General:
Cell ID: The default is 0.
Segment Number: The default is 0.
Total Uplink Duration: The default is 3.
Click Apply.
In Radio > Basic > Air Frame Structure Zones:
First Zone-Basic Map: The default is 6.
Downlink Data Zone-Permutation Base: The default is 0.
Uplink Feedback Zone-Permutation Base: The default is 0.
Uplink Data Zone-Permutation Base: The default is 0.
Click Apply.
In Radio > R6/R8 Bearer Interface > Bearer & Authentication:
Bearer Interface-IP Address.
Click Apply.
2.5.2
Configuring Radio Cluster Parameters
Using the Monitor Program
Select Sector > Radio Cluster Update and configure the following mandatory parameters:
Bandwidth
Center Frequency
TX Power
Using the Management System
1
Select Sector 1.
2
In the Radio Cluster section, configure the Bandwidth, Center Frequency and TX Power parameters of Radio Cluster 1.
3
Click Apply.