Справочник Пользователя для Telrad Networks Ltd COMPACT2X

Chapter 2 - CommissioningActivating the Unit

Chapter 2: Commissioning

Activating the Unit

BreezeCOMPACT System Manual

BreezeCOMPACT System Manual

At the Manager Number prompt, enter 1 and select the Update option. You are prompted to configure the Community 

Read Only and the Community Read and Write.

By default, the unit is supplied with one SNMP Traps Manager with the following parameters:



IP Address: 192.168.1.60



Port Number: 162 (This is the default port number used by the management system.)



Community: public



Enable Traps Distribution: enable

If different parameters are used by the management system, you should add an SNMP Traps Manager with the correct 

parameters. The IP Address of an existing SNMP Traps Manager cannot be updated.





Select BTS > Management > SNMP Traps Managers > Add. You are prompted to configure the IP Address, the Port 

Number, the Community and the Enable Traps Distribution parameter.

To apply the changes, reset the unit by selecting BTS > Unit Control > Shutdown operation > Update and then select the 

Reset option.

After the unit reboots, it should be discoverable and manageable from remote by the EMS station. 

If you do not use pre-prepared offline configuration files, the following section provides details about how to configure 

additional parameters required for activating the unit using either the management system (after discovering the unit) or the 

Monitor program.

To activate the unit you must:

Create the BS.

Define the Antenna(s).

Configure Radio Cluster parameters.

Once the unit can be discovered by the management system, the best way to complete the 
commissioning process is by using offline configuration files pre-prepared using the Mass 
Configuration Wizard. For more details, refer to the Using the Mass Configuration Wizard section in the 
Management System Infrastructure Manual and to the Using the Offline Tool Wizard section in the 
Device Driver Manual.