Справочник Пользователя для Nautel Maine Inc VS300

VS300 Operations and Maintenance Manual

Non-standard maintenance

Issue 0.1  2011-03-11

Page 4-3

7. In the Local Area Connection Status window, select 

Close

.

8. Close the Network Connections window.

Transfer software upgrade file to transmitter

1. If using a laptop, connect the laptop network interface card to the transmitter 

LAN (A1J8A) 

connector on the rear panel using a CAT5 Ethernet cable. Open Internet Explorer and 
search for 10.10.10.2. The transmitter login screen should appear.

2. If using a network computer, open Internet Explorer and search for the IP address recorded 

. The transmitter login screen should 

appear.

3. At the transmitter login screen enter:

– User: “Nautel” or “****”, where **** is the user assigned user name
– Password: leave blank (default) or “****”, where **** is the user assigned password

4. Navigate through the AUI to 

Menu

/

Software

/

Upload Files

, select the upgrade files tab 

and press 

Browse

. Locate the software update 

*.tgz

 file stored on the laptop or network 

computer, and press 

Upload

 to load the file into the transmitter upload file list. Allow this 

operation to complete.

Installing new software

1. Using the front panel UI, set the transmitter to 

RF Off

 and for 

Remote

 control. Perform the 

following steps remotely using the AUI on the laptop.

2. Go to the AUI 

Menu

/

Software

/

Upgrade Software

 screen and select the update 

*.tgz 

file 

from the Select Upload Files list (should highlight in blue) and press 

Start

.

CAUTION: 
If you are upgrading from a software version prior to V1.2, the ARM Watchdog 
feature must be DISABLED during the software upgrade process. Failure to 
observe this may result in a non-operational transmitter that will require a full 
operating system recovery. Refer to 

for details on disabling the ARM watchdog feature.

CAUTION: 
Do not leave this page until the flash process is complete.