Справочник Пользователя для Mitsubishi Electric Corp 485

Reference page

1. Turn on the VCR and peripheral devices.

2. Load a tape with an erasure prevention tab

intact.

3. Press the MODE button to select the desired

recording mode.

•

The recording mode shown on the
fluorescent display is based on using a T-
160 tape for recording.
Refer to Recording/playback time below for
the actual recording/playback time when T-
120 or T-160 tape is used.

4. Press the REC button to begin recording.

5. Press the PLAY/STOP button to stop recording.

The 2H (playback only), 8H modes, and the modes with the letter “L” (L24H and L40H)
are for audio recording and playback on the linear track.

•

If the tape you insert in your VCR has
the erasure prevention tab removed,
your VCR will automatically eject it if
you attempt to record on it.

•

The REC button will not function
unless a tape is in stop or pause
mode.

•

A tape recorded by this VCR may not
be played back correctly by another
VCR.

•

Press the PAUSE button to
momentarily stop recording.  Press it
again to resume recording.  To protect
the tape, the pause mode is
automatically cancelled after about
five minutes.

•

For the VCR’s movement when the
tape reaches its end during recording,
go to page 29.

•

Audio will not be recorded if a camera
with a built-in microphone or other
peripherals for audio are not
connected.

•

The longer the recording mode is set,
the worse the sound quality gets.  In
L40H mode, the sound quality is of
the degree that the speaking voice
can be heard.

(2h)

6h

18h
30h

(  ) is for playback only.

(2h 40min)

8h

24h
40h

MODE

REC

STOP

PLAY