Справочник Пользователя для Xiamen Four-Faith Communication Technology Co. Ltd. F8L10D-N
F8L10D-N LoRa Module User Manual
Page 21 of 33
Add：11th Floor, A-06 Area, No.370, Chengyi Street, Jimei, Xiamen, Fujian, China.
Chapter 4 Parameter Configuration
4.1 Configuration Connection
Before configuration, it’s need to connect the F8L10D with a host controller. The host
controller could be a PC or other device which contain UART port. You can connect the
F8L10D with PC by the Four-Faith F8L10D EVB, as showing in the figure 4-1.
Figure 4-1 F8L10D EVB connect with PC
4.2 Configuration Introduction
There are two ways to configure the device:
Four-Faith Configuration software tool
”LoRaConfig”: All the settings are
configured through the shipped software tool. It’s necessary to have one PC to
run this tool.
run this tool.
Extended AT command: All the settings are configured through AT command, so
any device with serial port can configure it. Before configuration with AT
command, you should make device enter configure state.
For more details, refer to
“AT command manual”.