Справочник Пользователя для Polygroup Trading Limited 1701

MADE IN CHINA

8

WARNING: UNPLUG THE POWER CORD BEFORE TROUBLESHOOTING THE GROW & STOW TREE.

A. Adaptor must be plugged into an AC outlet.

B. Foot pedal wire must be plugged into a DC jack of

adaptor, and other wires to tree

C. Check line voltage - must be 105 to 240 AC volts.

A. Set the lock switch to "

"       position

B.

Make sure all wires are properly connected and

locked. (see fig.3)

A.

Replace a brand new AAA/UM4/LR03 batteries

B.

Check batteries polarity diagram inside the

batteries case. (see fig 5)

C. Ensure the remote is operated within the range

 

(10 meters)

A.

Check all connectors of light string (plugs and jacks)

are connected on trunk (see main diagram point     )

B. Extra LED light bulb are included for replace an spare

LED light bulb

C. Make sure the light string cord is connected to foot

paddle and lock with ring screw.

(see fig.3)

A. Adjust the whole tree to flat ground surface.

A. Adjust pull the branches and tips up and out direction.

Prevent they cross jam together.

B. Press the button again on remote or foot pedal to

release PAUSE (see fig. 4)

A. Extra hinge pins are included for repairing the hinges.

Insert a new hinge pin through the hold and secure

using the retainer washer (see fig. 7 )

A. Adaptor is not plugged In

B. Foot pedal wires not connected

C. Low voltage

A. Foot pedal set on "

LOCK"      position

B. wires no connected

A.

Batteries out of power

B. Batteries install wrong polarity

C. You may out of effective range

5

1 No power on

Remote

control no

work

2

Tree 

mechanism

does not

works

6

7

3

4

11

No light on

Tree tilts

The tree

not complete

up or down 

Loose Hinge 

Pin

A. LED light string connector no

connected

B. LED light bulb missing or damage

C. Light string cord no connected to

Foot pedal

A. Wheel stand set on unflat ground

A. Tree branches and Tips make jam

each other

B. remote or foot pedal was pressed

PAUSE function

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or 

more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is    

connected.

•

Consult the dealer or an experienced radio/TV technician for help.