Справочник Пользователя для Mobileye Technology Ltd. MOB005
Technical Support
Mobileye 5 – Technical Installation Guide_Rev 0.1
Nov, 2011
Page 16 of 38
Mobileye Proprietary and Confidential
support@mobileye.com
5. Insert the EyeWatch cable (CAB000087) behind the vehicle the trimmings so
that it reaches the EyeWatch connector of the Mobileye 5 cable
(CAB000105)
.
WARNINGS!
- The EyeWatch and Main Unit should be placed in a location that does not obstruct
the driver’s field of view.
- The EyeWatch should not be placed in front of air-bags operational space. The unit
may prevent the air-bag from fully opening and/or may cause injury during air-bag
activation.
- Attaching the EyeWatch on the Vehicle’s windshield is not recommended
(
- The EyeWatch and Main Unit should be placed in a location that does not obstruct
the driver’s field of view.
- The EyeWatch should not be placed in front of air-bags operational space. The unit
may prevent the air-bag from fully opening and/or may cause injury during air-bag
activation.
- Attaching the EyeWatch on the Vehicle’s windshield is not recommended
(
EyeWatch may overheat).
3.2.4 Installing the Mobileye 5 Main Unit (Camera)
3.2.4.1 Selecting the optimal location for the Main Unit:
Select the optimal location for the Main Unit. Please comply with the following
requirements as incorrect positioning may affect the overall performance of the
system.
requirements as incorrect positioning may affect the overall performance of the
system.
The Main Unit should preferably be placed at the top of the
windshield (preferably at a height over 1.2 meter), in an area
well covered by the windshield wipers.
well covered by the windshield wipers.
The Main Unit should be placed at approximately the center
of the vehicle widthwise. If this is not possible it should be
within the central third of the vehicle width. It should be
noted that some car models have convex windshield
(sideways), which intensifies the problem of an off-center
installation.
within the central third of the vehicle width. It should be
noted that some car models have convex windshield
(sideways), which intensifies the problem of an off-center
installation.
The validation to the windshield edges allows an offset up to
25cm only. The preferable position of the Main Unit is in the
middle of the windshield. If this is not possible we allow up to
25 cm offset to one of the sides but no more so to not cause
reduction in system performance.
middle of the windshield. If this is not possible we allow up to
25 cm offset to one of the sides but no more so to not cause
reduction in system performance.
There should be no occlusions such as stickers or darkened
windshield areas in front of the Main Unit.