Справочник Пользователя для ICOM 272102

9

3

■ Turning power ON

q Rotate [VOL] to turn the power ON.
w If the transceiver is programmed for a start up passcode,

input the digit codes as directed by your dealer.

• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.

Therefore “01234” and “56789” are the same.

e When the “PASSWORD” indication does not clear after

inputting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.

■ Channel selection

Push [UP] or [DOWN], or rotate [ROTARY SELECTOR] to
select the desired system channel or talk group, in sequence.

• Up to 16 pre-programmed channels can be selected via [ROTARY

SELECTOR].

■ Call procedure

When your system employs tone signalling (excluding
CTCSS and DTCS), the call procedure may be necessary
prior to voice transmission. The tone signalling employed may
be a selective calling system which allows you to call specific
station(s) only and prevent unwanted stations from contact-
ing you.
q Select the desired DTMF encode channel according to

your System Operator’s instructions.

• This may not be necessary depending on programming.
• Refer to pgs. 11, 14, 16 for selection.

w Push the [PTT].
e After transmitting a DTMF code, the remainder of your

communication can be carried out in the normal fashion.

Selective calling

Non-selective calling

0

5

4

9

3

8

2

7

1

6

!IC-F43TR.qxd  04.1.14 7:03 PM  Page 9 (1,1)