Справочник Пользователя для SHEN ZHEN XING YAO HUA INDUSTRIAL CO. LTD T6AH-2400

◇Accessing the Swashplate Mix Function
Press the DOWN and SELECT keys simultaneously to access the Function Mode.

In function mode, press the UP or DOWN key to select the SWASH MIX screen.

Press the SELECT key to access the desired function (AILERON, ELEVATOR,

PITCH or EXPO).Press the INCREASE or DECREASE key to change the selected

swashplate mix value.

Note: Selecting a negative value will reverse the direction of the function.

Note:The cross plate's exponential function can be used,the compensation for non

linear output is caused by the loop servo's rotation. The exponential function can

eliminate the cross plate interaction in extreme times.
◆Throttle Hold
The Throttle Hold function is used to practice autorotation and is often use as a

safety switch for electric helicopters, holding the throttle in the off position. When

the throttle hold switch is activated, the throttle hold function holds the throttle

servo/ ESC in a specific position (normally low or off throttle) while all other servos

function normally. The throttle hold switch is also selectable. Switch selection

options include rudd D/R, gear, AUX2, aileron D/R or elevator D/R.

◇To Access the Throttle Hold Function
Press the DOWN and SELECT keys simultaneously to access the Function Mode.

In Function Mode, use the UP or DOWN key to select the THRO HOLD screen.

Press the INCREASE or DECREASE key to activate the throttle hold function.

When activated, press the INCREASE or DECREASE key to change the throttle

hold value.
◇To Access the Throttle Hold Switch Function
Press the SELECT key to highlight switch.

Press the INCREASE or DECREASE key to select the desired switch.

◆Throttle Curve
The T7AH-2400 offers three (3) separate throttle curves with five (5) adjustable

points per curve. This function allows you to adust the throttle curve to optimize

engine rpm at a particular pitch setting. Once the throttle curves are established,

each can be activated in flight using the 3-position flight mode switch. The flight

mode switch offersthree (3) selectable curves: N=Normal, 1=Stunt 1, 2=Stunt 2.

The N, or Normal, position should be used for starting the engine and hovering.

Positions 1 and 2, or Stunt 1 and Stunt 2, should be used for aerobatic maneuvers

and forward flight.

Note: The throttle trim and hovering throttle lever are only operable when the flight

mode switch is in the Normal position. Thus, in the 1 or 2 positions, these two

functions have no effect. Each of the five (5) positions of the throttle curve are

independently adjustable from 0–100%. These five (5) positions correspond to

the position of the throttlestick.The transmitter is factory preset to the throttle

curve as indicated by the solid line in the figure below. Individual points can be

activated and increased/decreased to suit your specific needs.

◇To Access the Throttle Curve Function
Press the DOWN and SELECT keys simultaneously to access the System Mode.

Press to enter SWASH MIX

Press to adjust value

Hold white turning

on the transmitter

[SWASH MIX]

3 SERVO

120

EXP INH

AILE+ 60%

ELEV+ 60%

PIF. + 60%

Press to reset

value to default

[THRO HOLD]

SW:RUDD D/R

HOLD POS. -5.0%

Press to enter
THROTTLE HOLD

Press to enter
Function Mode

Press to return
value to INH

Press to select
desired channel

Press to activate

THROTTLE

HOLD

and change values

Press to adjust values

[THRO CURVE]

NORM

Point-L

0.0%

OUT

Press to enter
THROTTLE CURVE

Press to enter
Function Mode

Press to select
desired points

Press to return
value to default