Справочник Пользователя для Innokas Yhtyma Oy VC150

9-22

VC150 Vital Signs Monitor

KO00065K

: Nellcor SpO

2

 and special features

Use only Covidien-approved sensors and interface cables when 
connecting to the sensor port. Connecting any other cable or sensor 
influences the accuracy of sensor data, which may lead to adverse 
results.

The top of the monitoring system screen indicates the sensor type when 
connecting a recommended sensor to the monitoring system or when the 
monitoring system completes POST with an attached sensor.

Physiological conditions such as excessive patient movement, medical 
procedures, or external agents such as dysfunctional hemoglobin, arterial 
dyes, low perfusion, dark pigment, and externally applied coloring agents 
such as nail polish, dye, or pigmented cream may interfere with the 
monitoring system¡¦s ability to detect and display measurements.

Sensor LED light emissions fall within Class 1 level, according to IEC 60825-
1:2001.

To fully connect a Nellcor sensor

1. Firmly connect a Nellcor interface cable to the monitoring system¡¦s sensor 

port. Reference 

on page 2-2, to identify the port.

2. Open the plastic latch at the other end of the interface cable.

3. Plug the interface cable and recommended sensor together.

4. Snap the plastic latch down over the connectors.

5. When the monitoring system detects a valid pulse, it enters the monitoring 

mode and displays real-time patient data.

6. Apply the recommended sensor to the patient after reading the Instructions 

for Use accompanying the sensor.

7. Detach the recommended sensor from the patient on completion of 

monitoring.