Справочник Пользователя для Fortin Auto Radio Inc. A2W01FM
If the vehicle fails to start on the first attempt, the Remote-Starter will wait 3 seconds before it will attempt
to start the vehicle again. The Remote-Starter will attempt to start the vehicle 2 times (default) before
giving up. (See Failed Remote Start page 13)
to start the vehicle again. The Remote-Starter will attempt to start the vehicle 2 times (default) before
giving up. (See Failed Remote Start page 13)
ACCESSORY PRESET
Heater & Heated Seat(s):
When leaving the vehicle it is recommended that the driver pre-set the climate controls
in preparation for a later Remote-Start. When the vehicle Remote-Starts, the current (or last) setting for the climate
controls, windshield wipers (and other accessories) will be used. When setting the blower motor (fan speed) and
heated seats (if equipped) should not be left on HIGH. It is recommended to leave these settings on either a LOW
or MEDIUM setting.
controls, windshield wipers (and other accessories) will be used. When setting the blower motor (fan speed) and
heated seats (if equipped) should not be left on HIGH. It is recommended to leave these settings on either a LOW
or MEDIUM setting.
Windshield Wipers & Radio & Headlights:
Some vehicles require the radio, windshield wiper, headlight circuits
to become energized while running under Remote-Start. When leaving the vehicle you must ensure that the wind-
shield wiper and headlight switches are turned off. Leaving the headlights on with some vehicles could cause them
to remain on even after the Remote-Starter has shut down, resulting in a dead battery.
shield wiper and headlight switches are turned off. Leaving the headlights on with some vehicles could cause them
to remain on even after the Remote-Starter has shut down, resulting in a dead battery.
Rear Defrost:
On most vehicles the Rear Defrost can only be activated after the vehicle has been started and in
most cases this feature is not included with a Remote-Starter installation. On some vehicles it may be possible for
the installer to hook this feature up so it either automatically enables after Remote-Start or can be enabled by using
an AUX output. (See Auxiliary Outputs page 10)
the installer to hook this feature up so it either automatically enables after Remote-Start or can be enabled by using
an AUX output. (See Auxiliary Outputs page 10)
Driver Presets:
Some vehicles retain different seat, mirror and radio settings for each driver. Different driver
presets are not controlled by the Remote-Starter, however they may be controlled with the Bypass/Interface Kit.
READY MODE (MANUAL TRANSMISSION ONLY)
Two activation methods are possible, please consult the salesman or installer to determine which of these modes
applies to your vehicle.
There are always safety concerns for a manual transmission vehicle to accidentally start while in gear, Ready Mode
alleviates these concerns. The driver must enable Ready Mode in order to Remote-Start the vehicle at a later time.
Once Ready Mode is setup the vehicle can be started/stopped at will, as many times as needed. However once the
parking brake is disengaged, the hood is opened, or any of the doors are opened, Ready Mode will deactivate and the
vehicle will not start until Ready Mode is reactivated.
applies to your vehicle.
There are always safety concerns for a manual transmission vehicle to accidentally start while in gear, Ready Mode
alleviates these concerns. The driver must enable Ready Mode in order to Remote-Start the vehicle at a later time.
Once Ready Mode is setup the vehicle can be started/stopped at will, as many times as needed. However once the
parking brake is disengaged, the hood is opened, or any of the doors are opened, Ready Mode will deactivate and the
vehicle will not start until Ready Mode is reactivated.
METHOD 1 ACTIVATION :
STEP 1
and
Make sure that all doors are closed and the transmission is
in the NEUTRAL position.
in the NEUTRAL position.
STEP 2
Engage the parking brake.
STEP 3
Release the brake pedal.
STEP 4
The remote Green Led flash and a ascending melodie will
sound to confirm. The parking lights will flash once and
then remain on.
sound to confirm. The parking lights will flash once and
then remain on.
STEP 5
Remove the key from the ignition barrel.
The vehicle will remain running with the Remote-Starter.
The vehicle will remain running with the Remote-Starter.
STEP 6
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors
are closed.
The Remote-Starter will stop running once all the doors
are closed.
STEP 7
Lock the doors by pushing the LOCK button. The remote
Green Led flash and bip once to confirm.
Green Led flash and bip once to confirm.
METHOD 2 This method must be enabled by the installer during installation. ACTIVATION:
STEP 1
Make sure the transmission is in the NEUTRAL position.
Page 5 / 13