Справочник Пользователя для IBM Flex System V7000 Expansion Enclosure 4939H29
Модели
4939H29
8068ch12-Host Config.fm
Draft Document for Review January 29, 2013 12:52 pm
516
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Check Zoning
On the IBM Flex System FC3171 8Gb SAN Switch. the zoning is checked as shown in
Figure 12-62. Here, the WWN is defined in zone with IBM Flex System V7000 Storage Node
canisters.
Figure 12-62. Here, the WWN is defined in zone with IBM Flex System V7000 Storage Node
canisters.
Figure 12-62 Check WWN is defined in zone
Again, this check should be repeated on the second IBM Flex System FC3171 8Gb SAN
Switch for the second HBA fcs1.
Switch for the second HBA fcs1.
Check Host Definition on IBM Flex System V7000 Storage Node
From the administration access of IBM Flex System V7000 Storage Node Figure 12-63
shows both HBAs WWNs are correctly displayed in a defined host.
shows both HBAs WWNs are correctly displayed in a defined host.
Figure 12-63 WWNs displayed of defined Host
12.5.4 Installing the 2145 host attachment support package
To correctly configure multipathing of IBM Flex System V7000 Storage Node volumes to an
AIX compute node requires the proper device type of 2145 which should be displayed when
querying with AIX (lsdev -Cc disk command later shown). The 2145 host attachment support
fileset is required prior to running cfgmgr which searches for new devices. Running cfgmgr
prior to installing the host attachment support fileset will result in the LUNs being configured
AIX compute node requires the proper device type of 2145 which should be displayed when
querying with AIX (lsdev -Cc disk command later shown). The 2145 host attachment support
fileset is required prior to running cfgmgr which searches for new devices. Running cfgmgr
prior to installing the host attachment support fileset will result in the LUNs being configured