Техническая Спецификация для PeakOptical PGBIC-15215SF
Data Sheet
1.25Gb/s, Hot Pluggable, Duplex SC, +5V, 1550nm DFB,
Single-Mode Gigabit Interface Converters Transceiver
PGBIC-15215SF
PGBIC-15215SF
Issue: October 2008
All rights reserved, including intellectual property rights. Technical data subject to modifications and delivery subject to availability. Any liability
that the data and illustrations are complete, actual or correct is excluded. Designations may be trademarks and/or copyrights of the respective
manufacturer, the use of which by third parties for their own purposes may infringe the rights of such owner.
that the data and illustrations are complete, actual or correct is excluded. Designations may be trademarks and/or copyrights of the respective
manufacturer, the use of which by third parties for their own purposes may infringe the rights of such owner.
Copyright © PeakOptical Technology A/S 2008-2010. Published at www.peakoptical.com
Timing Characteristics:
Parameter
Symbol
Min. Typical Max. Unit
TX_DISABLE Assert Time
t_off
-
3
10
usec
TX_DISABLE Negate Time
t_on
-
0.5
1
msec
Time to Initialize Include Reset of TX_FAULT
t_int
-
30
300
msec
TX_FAULT from Fault to Assertion
t_fault
-
20
100
usec
TX_DISBEL Time to Start Reset
t_reset
10
-
-
usec
Receiver Loss of Signal Assert Time (Off to On)
T
A
,RX_LOS
-
-
100
usec
Receiver Loss of Signal Assert Time (On to Off)
T
d
,RX_LOS
-
-
100
usec
Block Diagram of Transceiver
Pinout Table:
Pin
Signal Name
I/O Type Functional Description
1
RX_LOS
Output
Receiver Loss of Signal, Logic high, Open collector compatible
4.7K to 10K Ohm pulls up to V
4.7K to 10K Ohm pulls up to V
DD
T on host.
2
RGND
Receiver Ground
3
RGND
Receiver Ground
4
MOD_DEF(0)
Output
Module Definition 0 TTL Low
5
MOD_DEF(1)
Input
Module Definition 1 Two wire serial ID interface SCL, 4.7K to
10K Ohm pull up to V
10K Ohm pull up to V
DD
T on host
6
MOD_DEF(2)
I/O
Module Definition 2 Two wire serial ID interface SDA, 4.7K to
10K Ohm pull up to V
10K Ohm pull up to V
DD
T on host
LD
Driver
+Tx_ DAT
-Tx_ DAT
LD
Tx_ Disable
Tx_ Fault
MOD_DEF(0)
MOD_DEF(1)
MOD_DEF(2)
MOD_DEF
Post-Amp
+Rx_ DAT
-Rx_ DAT
Rx_ LOS
Pre-
Amp
Optical
Sub-assembl
Duplex LC
Receptacle