Техническая Спецификация для Renkforce Digitale Funk-Wetterstation sw Wireless Weather Station E0303H2TPR

•  To start setting mode, keep the button „SET“ (7) pushed for about 3 seconds until the

year flashes in the display.

•  Set the year with the buttons „UP“ and „DOWN“.
  Keep the respective button pressed for quick adjustment. 

  If you do not push any button for a few seconds, the settings made until then 

are saved and setting mode is left.

 

This also applies to the following settings.

•  Briefly push the button „SET“ (7). The month flashes. Set it with the buttons „UP“ and

„DOWN“. 

•  Briefly push the button „SET“ (7). The date flashes. Set it with the buttons „UP“ and

„DOWN“. 

•  Briefly push the button „SET“ (7). The hours of the time flash. Set them with the buttons

„UP“ and „DOWN“.

•  Briefly push the button „SET“ (7). The minutes of the time flash. Set them with the

buttons „UP“ and „DOWN“. Each push of a button will also automatically reset the 

seconds to „00“. 

•  Briefly push the button „SET“ (7). The display „12Hr“ or „24Hr“ for 12h/24h display

mode for the time flashes. Set the desired mode with the buttons „UP“ or „DOWN“.

  In 12h mode, „PM“ is displayed to the left of the time in the second half of the 

day.

•  Briefly push the button „SET“ (7). The time zone flashes. Set it in the range of -12 to

+12 hours with the buttons „UP“ and „DOWN“. 

•  Briefly push the button „SET“ (7) to leave setting mode.

  If the radio tower symbol for the DCF reception disappears, even though only 

the time zone or the 12h/24h mode has been changed, you can either start a 

manual reception attempt for the DCF signal (see above) or you can wait for a 

day so that the weather station starts a daily reception attempt.