Техническая Спецификация для Reely ARF 911 mm PC-21

The fin is attached to the fuselage with double-sided adhesive tape.
The adhesive tapes required for this are already installed to the fin.

Assembly positions that are not perfect are difficult to correct. For this
reason, we recommend performing this work with a helper.

Try placing the fin (1) into the intended position in the fuselage (2). The
large side of the fun points backwards here.

Imprecise fits should be carefully corrected with a cutter knife and/or
fine sand paper. Observe that removal of the protective film provides a
little more clearance to facilitate assembly.

Remove the fin again after successful verification.

Remove the protective film from the fin. Install the fin again in the
fuselage as tried “dry” again before. When the fin is perfectly seated in
the intended position, push it firmly into the fuselage.

The rudder is attached to the fuselage with double-sided adhesive tape.
The adhesive tape required for this is already installed at the fuselage.

Assembly positions that are not perfect are difficult to correct. For this
reason, we recommend performing this work with a helper.

Try placing the rudder (1) into the intended position in the fuselage (2).

Imprecise fits should be carefully corrected with a cutter knife and/or
fine sand paper. Observe that removal of the protective film provides a
little more clearance to facilitate assembly.

Remove the rudder again after successful verification.

Remove the protective films from the fuselage. Install the rudder again
in the fuselage as tried “dry” again before.

When the rudder is perfectly seated in the intended position, push it
firmly into the fuselage.