Техническая Спецификация для Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8
Модели
6ED1057-3BA00-0AA8
Reference material
5.3 Special functions
LOGO!Soft Comfort Online Help
Operating Instructions, 06/2014
Operating Instructions, 06/2014
219
Parameter
T: The output is switched off on expiration of the delay time T (output signal
transition 1 to 0).
Retentivity on = the status is retentive in memory.
Output Q
Q switches on for the duration of the time T after a trigger at input Trg.
Parameter T
The actual value of another already-programmed function provides the time set in parameter
T:
● Analog comparator: Ax - Ay
● Analog threshold trigger: Ax
● Analog amplifier: Ax
● Analog multiplexer: AQ
● Analog ramp: AQ
● Mathematic instruction: AQ
● PI controller: AQ
● Up/Down counter: Cnt
For the 0BA7 and 0BA8 devices, you can additionally use the actual values of the following
● Analog comparator: Ax - Ay
● Analog threshold trigger: Ax
● Analog amplifier: Ax
● Analog multiplexer: AQ
● Analog ramp: AQ
● Mathematic instruction: AQ
● PI controller: AQ
● Up/Down counter: Cnt
For the 0BA7 and 0BA8 devices, you can additionally use the actual values of the following
already-programmed functions:
● On-delay: Ta
● Off-delay: Ta
● On-/off-delay: Ta
● Retentive on-delay: Ta
● Wiping relay(pulse output): Ta
● Edge triggered wiping relay: Ta
● Asynchronous pulse generator: Ta
● Stairway light switch: Ta
● Multiple function switch: Ta
● Stopwatch: AQ
● Analog filter: AQ
● Average value: AQ
● Max/Min: AQ
● Threshold trigger: Fre
You select the required function by the block number.
For information on the validity and accuracy of the time base, refer to the
● On-delay: Ta
● Off-delay: Ta
● On-/off-delay: Ta
● Retentive on-delay: Ta
● Wiping relay(pulse output): Ta
● Edge triggered wiping relay: Ta
● Asynchronous pulse generator: Ta
● Stairway light switch: Ta
● Multiple function switch: Ta
● Stopwatch: AQ
● Analog filter: AQ
● Average value: AQ
● Max/Min: AQ
● Threshold trigger: Fre
You select the required function by the block number.
For information on the validity and accuracy of the time base, refer to the
LOGO! Manual
.