Справочник Пользователя для Grandstream cordless VoIP-telephone DP715
Модели
DP715
Firmware version 1.0.0.21
DP715/DP710 User Manual
Page 28 of 52
“Device not registered”
This prompt will be played immediately after off hook If the device is
not register and the
not register and the
option “Outgoing Call without Registration” is in
NO
Five Success Tips when using the Voice Prompt
1.
“*” shifts down to the next menu option
2.
“#” returns to the main menu
3.
“9” functions as the ENTER key in many cases to confirm or toggle an option
4. All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168000026. No decimal is needed).
should be key in like 192168000026. No decimal is needed).
5. Key entry cannot be deleted but the phone may prompt error once it is detected.
REGISTERING A HANDSET TO THE DP715 BASE STATION
You can register up to 5 handsets to one DP715 base station. Each handset can, for its part, be registered
to up to four base units and the user can choose which base unit he wishes to use. In the default setting as
supplied, each handset is registered as Handset 1 to Base unit 1.
Note: The original handset included in the DP715 package is pre-registered to the Base.
To register any additional Handset, please follow these steps:
1. Turn on the handset.
2. Press .
3. Press or repeatedly, select Handset.
4. Press to confirm.
5. Press or repeatedly, select Registration.
6. Press to confirm.
7. Select
to up to four base units and the user can choose which base unit he wishes to use. In the default setting as
supplied, each handset is registered as Handset 1 to Base unit 1.
Note: The original handset included in the DP715 package is pre-registered to the Base.
To register any additional Handset, please follow these steps:
1. Turn on the handset.
2. Press .
3. Press or repeatedly, select Handset.
4. Press to confirm.
5. Press or repeatedly, select Registration.
6. Press to confirm.
7. Select
“Register” and press .
8. Select the base unit (1-4) desired using or and press .
9. Enter the base unit PIN (System PIN; default: 0000) and press
.
10. Restart base appears in the display.
At this stage, the message
“Restart base” will appear on the display. This requires the DP715 base
station to be in subscription mode simultanrously, which can be either enabled from the web
configuration menu or by powering cycle the base.
configuration menu or by powering cycle the base.
The handset will now search for the base unit and register when it has found it. The display shows
standby mode after a successful registration and the handset name and handset number appear.
Note:
It is not possible to make or receive calls while the base unit is in registration mode.