Техническая Спецификация для Cisco Wireless-G Access Point PoE WAP200-EU
Модели
WAP200-EU
Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 2 of 5
The advanced security features make this solution ideal for your business. Advanced wireless
security using Wi-Fi Protected Access (WPA2) with up to 256-bit encryption, and Wireless Security
Monitoring give your business the visibility and protection it needs. Used when Cisco
®
WUSB 200,
WMP200 or WPC200 Wireless adapters are present, Wireless Security Monitoring alerts you of
possible wireless intruders and vulnerabilities in the wireless deployment and gives you visibility
into denial-of-service attacks.
The Cisco WAP200 Wireless-G Access Point (Figure 1) lets you connect Wireless-G (802.11g) or
Wireless-B (802.11b) devices to your wired network so you can add PCs to the network with no
cabling hassle. Power over Ethernet (PoE) support makes it easy to install - you can mount the
access point anywhere, even without ready access to a power plug. With appropriate PoE support
at the other end, you need to run only one cable to the access point to deliver both data and
power. Of course, you can also use the included AC adapter if power is available nearby.
The integrated quality of service (QoS) features provide consistent voice and video quality on both
the wired and wireless networks, enabling the deployment of business-quality voice over IP (VoIP)
and video applications.
Additional features like multiple basic service set identifiers (BSSIDs), wireless roaming, and auto-
channel selection, make this solution ideal for your business.
Features
●
10BASE-T/100BASE-TX Ethernet port, autosensing half/full duplex and medium dependent
interface (MDI) and MDI crossover (MDI-X)
●
Full backward compatibility with 802.11b
●
Easy installation and configuration
●
Supports Wired Equivalent Privacy (WEP), WPA Pre-Shared Key (WPA-PSK), WPA2-PSK,
WPA-ENT, and WPA2-ENT authentication (802.11i ready)
●
SMA detachable dipole antennae with 1x2 multiple-input, multiple-output (MIMO) to increase
coverage
●
Supports PoE or external DC power
●
Supports 4 BSSID and 802.1Q VLAN to service set identifier (SSID) mapping
●
Supports Simple Network Management Protocol (SNMP) and features an intuitive web-based
interface
●
Wi-Fi Multimedia (WMM) wireless QoS support, upgradable to 802.11e
●
Supports wireless roaming based on 802.11F (Inter-Access Point Protocol [IAPP])
●
Supports access point, bridge mode, and repeater mode
●
Supports wireless security monitoring (working together with Cisco WUSB 200, WMP200 or
WPC200 client cards)
●
Supports wireless client isolation