Техническая Спецификация для Cisco Wireless-G Access Point PoE WAP200-EU
Модели
WAP200-EU
Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 3 of 5
Specifications
Table 1 gives specifications, package contents, and minimum requirements for the Cisco WAP200
Wireless-G Access Point.
Table 1.
Specifications for the Cisco WAP200 Wireless-G Access Point: PoE/RangeBooster
Specifications
Standards
IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS
priority), 802.1q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2),
802.11e ready (wireless QoS), 802.11F (wireless roaming)
priority), 802.1q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2),
802.11e ready (wireless QoS), 802.11F (wireless roaming)
Ports
10BASE-T/100BASE-TX Ethernet, 12V DC power
Buttons
Reset
Cabling type
Unshielded twisted pair (UTP) Category 5
LEDs
Power, PoE, Wireless, Ethernet
Operating system
Linux
Setup/Configuration
Web user interface
Built-in web user interface for easy browser-based configuration (HTTP/HTTPS)
Management
SNMP version
SNMP version 1, 2c, 3
Event logging
●
Email notification
●
Remote syslog
Web firmware upgrade
Firmware upgradable through web browser
Diagnostics
Flash, RAM, LAN, WLAN
Dynamic Host Configuration
Protocol (DHCP)
Protocol (DHCP)
DHCP client
Operating Modes
Access point
Access point mode, point-to-point bridge mode, point-to-multipoint bridge mode, repeater
mode
mode
Wireless
Spec/modulation
Radio and modulation type: 802.11b/DSSS, 802.11g/OFDM
Channels
Operating channels: 11 North America, 13 most of Europe (ETSI and Japan)
External antennas
2 (omnidirectional) SMA detachable
Transmit power
Transmit power (adjustable) at normal temperature range:
●
802.11b: 18~19 dBm
●
802.11g: 14~15 dBm
Antenna gain in dBi
2
Receiver sensitivity
802.11.g: 54 Mbps at -72 dBm, 802.11.b: 11 Mbps at -85 dBm
Security
WEP/WPA/WPA2
WEP 64-bit/128-bit, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT
Access control
Wireless connection control: MAC-based
SSID broadcast
SSID broadcast enable/disable
802.1X
IEEE 802.1X support
Wireless client isolation
Wireless client devices can be isolated from each other either within an SSID or between 2
SSIDs
SSIDs
Wireless Security Monitor
Scan and classify wireless devices in the network
Report new client and access point joining network and suspicious network events (works
together with Cisco WUSB 200, WMP200 or WPC200 business client adapters):
together with Cisco WUSB 200, WMP200 or WPC200 business client adapters):
●
Intrusion alarms (e.g., rogue client detected, spoofed MAC address)
●
Denial-of-service alarms (e.g., duration attack, association table full)
●
Vulnerability alarms (e.g., access point is not using encryption, access point is
broadcasting SSID)
●
Other alarms (e.g., low speed connection)