Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

Receiver voltage „RX battery“
Depending on the receiver voltage supply used, this menu can be used to set the voltage values where the remote 

control visually and acoustically displays threatening deep discharge.
To set the receiver voltages, proceed as follows:
•  Call the „RX Setup“ menu.
•  Use the buttons „UP“ or „DOWN“ to select the menu item „RX

Battery“ and activate it with the button „OK“.

•  Use the buttons „UP“ and „DOWN“ to set the lowest voltage

value „Low“ that is already selected with the cursor arrow. If 

the button „OK“ is pushed and held, the factory parameters 

are called.

•  Briefly push the button „OK“ to switch to the next-higher volta-

ge value „Alarm“. The setting is made with buttons „UP“ and 

„DOWN“ again. 

•  Use the button „OK“ to switch to the voltage value at fully char-

ged rechargeable battery „High“ and again set the required 

value with the buttons „UP“ or „DOWN“.

•  Keep the button „CANCEL“ pushed for a longer period to save

the set voltage values. The display then shows the system 

setup menu again.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display.

  Since the adjustable voltage values depend on each 

other, it may be required to increase the voltage value 

for a fully charged rechargeable battery first, to then

be able to enter higher alarm values as well.

 

If the set thresholds are undercut, the battery icon for 

the receiver battery will flash at operation of the remo-

te control and the remote control transmitter will make 

warning or alarm sounds.